This machine is simple to set up
and easy and accurate to use.
It is made to machine shop
standards and is ruggedly built into a heavy duty ABS cabinet. The main shaft
is fully supported by ball bearings.
This machine is patterned after the
one that I've been using in my workshop for the past 8
or so years.
Technical Description
This coil winding machine is
designed to properly wind coils using
wire ranging from approximately 32 ga. up to
46 ga.
The coil winder consists of a
strong, heavy wall ABS box with counter-rotating arms. The winder's arms rotate in opposite
directions to allow you to wind coils in either a clockwise or counter-clockwise manner.
The entire assembly is mounted on
a sturdy composite base.
Mounted in front of the tower is
the cross feed limiter. The limiter is used to preset the span at
which the coil wire can be wound across the bobbin.
A re-settable digital
rotation counter is mounted on
the front of the tower assembly.
The tension on the wire, as well
as the movement of the wire between the cross feed limits, is done by hand.
Features
Everything is now built into a heavy duty
ABS cabinet
Variable electronic speed control
standard.
Re-settable digital rotation counter.
Drive belt location moved to outside for
easier maintenance.
Power supply: External 9
volt
Technical Specifications
Maximum speed (no load):
900 RPM
Actual winding speed (as tested
under load): 750 RPM
Feet per minute (tested actual winding
speed at full torque): 400 f.p.m.
Time required to wind an average
5.6k strat type single coil: approximately 9 minutes.
Please select the machine with the proper
voltage requirements for your area.
Model
In
Stock
Price
Quantity
ECWN Coil Winding Machine -
for North
America - 110 volt power
Yes
$349.95
ECWE
Coil Winding Machine -
for Europe - 220 volt power
Not ROHS
compliant at the present time
NO
$369.95
Need
some coil wire to go with it?
42
Gauge Coil Wire (1/2 lb. spool)
Yes
$24.95
43
Gauge Coil Wire (1/2 lb. spool)
Yes
$27.95
44
Gauge Coil Wire (1/2 lb. spool)
Yes
$33.95
Prices shown are in US funds
Canadian customers wishing to order online click here:
A note
about preamps, DI's, mixers, boards: This pickup is
designed to work properly running from our pickup into any
normal amp (guitar amp, bass amp, etc.).
Due to design factors inherent in P.A. mixers and boards (and these
vary considerably), if you are running straight into a P.A., then a
Preamp/ DI will most likely
be necessary to boost line signal strength
and lower the impedance so that the mixer
receives a proper signal.
If you
would prefer to speak to us directly, please feel free to contact us toll
free (877) 633-0177 Monday to Friday 9 AM to
5 PM eastern time.Toll free is for
the US and Canada only, the rest of the world may call
519-742-3862.
We accept Visa, Mastercard, and American
Express on phone orders
This website, all articles,
photographs, and information contained herein are and remain the property of schatten
design and may not be copied or reproduced in whole or in part without
permission. (c) 2008 schatten design.
