Schatten EP-01 Utility Transducer

An inexpensive, yet mighty little soundboard transducer

     The EP-01 is a small, light weight piezo sensor that is meant for one time installation on an instrument's soundboard. The pickup comes with 18" of shielded cable and is not supplied with an output jack (due to the 'utility' nature of this unit).

     Since this unit is meant primarily for protected interior installations, the piezo element is not 'potted', but is instead covered with an acoustic foam pad. Due to the nature of the piezo and the fact that it is not a 'potted' unit, this pickup has great output and full response. No preamp is required.

This pickup is not suggested for stage use.

EP-01 Utility Transducer

Prices shown are in US funds

A note about preamps, DI's, mixers, boards: This pickup is designed  to work properly running from our pickup into any normal amp (guitar amp, bass amp, etc.).

Due to design factors inherent in P.A. mixers and boards (and these vary considerably), if you are running straight into a P.A., then a Preamp/ DI will most likely  be necessary to boost line signal strength and lower the impedance so that the mixer receives a proper signal.

 

If you would prefer to speak to us directly, please feel free to contact us toll free (877) 633-0177  Monday to Friday 9 AM to 5 PM eastern time. Toll free is for the US and Canada only, the rest of the world may call 519-742-3862.

We accept Visa, Mastercard, and American Express on phone orders

01/14/2008